Rendezvous AWD V6-3.4L VIN E (2005)
Brake Caliper: Service and Repair
Brake Caliper Bracket Replacement
Front
Brake Caliper Bracket Replacement - Front
Removal Procedure
1. Caution: Refer to Brake Dust Caution in Service Precautions.
Notice: Support the brake caliper with heavy mechanic's wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible
brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which
may cause damage to the brake hose and in turn may cause a brake fluid leak.
Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire, or equivalent. It is not necessary to disconnect
the hydraulic brake flexible hose from the caliper.
2. Remove the front brake pads.
3. Remove the caliper bracket bolts (2).
4. Remove the caliper bracket (1).
Installation Procedure
1. Important: To ensure that the proper clamp load will be present when installed. It is imperative that the threads on the caliper bracket bolts, as
well as the mounting holes in the knuckle, be cleaned of all debris and inspected before proceeding with installation.
Clean and visually inspect the threads of the caliper bracket bolts (2) and mounting holes in the knuckle.
3. Apply threadlocker, GM P/N 12345493 (Canadian P/N 10953488), or equivalent, to the threads of the brake caliper bracket bolts (2).
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the caliper bracket (1) with the bracket bolts (2).
Tighten the caliper bracket bolts to 185 Nm (137 ft. lbs.).
5. Install the front brake pads.
6. Install the caliper.
