Rendezvous AWD V6-3.4L VIN E (2005)
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the coolant heater bolt.
^
Tighten the bolt to 2 Nm (18 inch lbs.).
Notice: The heater cord must not touch the engine, hot pipes, manifold, or any moving parts. Route the cord to the left front of the engine
compartment securing with tie straps as necessary to prevent damage.
5. Install the engine coolant heater cord to the engine coolant heater.
6. Install the right engine splash shield.
7. Install the right front wheel.
8. Lower the vehicle.
9. Fill the engine cooling system.
