Rendezvous AWD V6-3.4L VIN E (2005)
Notice: Refer to Fastener Notice in Service Precautions.
3. Perform the following steps in order to install the crankshaft rear oil seal.
^
Align the dowel pin of the J 34686 with the dowel pin in the crankshaft.
^
Attach the J 34686 to the crankshaft by hand, or tighten the attaching screws to 5 Nm (45 inch lbs.).
^
Turn the T-handle of the J 34686 in order to engage allow the collar to push the seal into the bore. Turn the handle until the collar is tight
against the engine block. Ensure that the seal is seated properly.
^
Loosen the T-handle until the T-handle comes to a stop.
^
Remove the attaching screws.
4. Install the flywheel.
