Rendezvous AWD V6-3.4L VIN E (2005)
Exhaust Pipe/Muffler Hanger: Service and Repair
Converter Hanger Assembly Replacement
Removal Procedure
1. Raise and suitably support the vehicle.
2. Remove the catalytic converter hanger insulators from the catalytic converter.
3. Remove the catalytic converter hanger bolts.
4. Remove the catalytic converter hanger.
Installation Procedure
1. Install the catalytic converter hanger.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the catalytic converter hanger bolts.
Tighten the catalytic converter hanger bolts to 45 Nm (33 ft. lbs.).
3. Install the catalytic converter hanger insulators to the catalytic converter.
4. Lower the vehicle.
