Rendezvous AWD V6-3.4L VIN E (2005)
3. Connect the mode actuator push rod (2) to the retainer clip (1).
IMPORTANT: Align the counted number of threads on the mode actuator push rod (2) with the tip of the retainer clip (1).
4. Close the push rod retainer clip (1).
5. Connect the mode actuator electrical connector.
6. Connect the I/P wiring harness clip to the I/P support bracket.
7. Install the knee bolster.
8. Recalibrate the actuators. Refer to Re-Calibrating Actuators.
