Rendezvous AWD V6-3.4L VIN E (2005)
9. Remove the headlamp trim from the headlamp, pulling to release the adhesive tape.
10. Clean adhesive from the headlamp trim and headlamp using 3M(TM) adhesive remover P/N 8984, or equivalent.
INSTALLATION PROCEDURE
1. Install new adhesive tape 3M(TM) P/N 6382 or equivalent to the headlamp trim, if necessary.
2. Position the headlamp trim to the headlamp, if removed.
3. Install the headlamp trim to the headlamp, pressing until end tabs are fully seated.
4. Install the headlamp bulb(s) to the headlamp by rotating clockwise.
5. Connect the electrical connector to the headlamp.
IMPORTANT: The headlamp electrical connector must be positioned into the upper fascia support panel for proper seating of the headlamp.
6. Position the headlamp to the upper fascia support.
