Rendezvous AWD V6-3.4L VIN E (2005)
10. Remove the fuel feed, fuel return, and EVAP pipe attaching hardware, and the fuel feed, fuel return, and EVAP pipes.
11. Note the position of the fuel and EVAP pipes and the fuel and EVAP pipe attaching hardware for installation.
12. Inspect the pipes for bends, kinks, and cracks.
13. Replace the pipe or pipes as required.
INSTALLATION PROCEDURE
1. Install the new fuel feed, fuel return, and EVAP pipes and attaching hardware as noted during removal.
CAUTION: In order to Reduce the Risk of Fire and Personal Injury: If nylon fuel pipes are nicked, scratched or damaged during
installation, they must be replaced.
NOTE: Always re-attach the fuel lines and fuel filter with all original type fasteners and hardware.
Do not repair sections of fuel pipes.
NOTE:
-
Secure the fuel pipes to the frame in order to prevent chafing. Maintain a minimum of 13 mm (1/2 inch) clearance around a pipe in order to
prevent contact and chafing. Maintain a minimum of 19 mm (3/4 inch) around any moving part.
-
Do not allow the fuel pipes to come into contact with the fuel tank or underbody.
IMPORTANT: If the fuel line attaching hardware is damaged or broken, replace the hardware.
2. Remove the caps from the in-pipe fuel filter pipe, the fuel feed pipe, and the fuel return pipe.
