Rendezvous AWD V6-3.4L VIN E (2005)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position (CKP) Sensor Replacement
CRANKSHAFT POSITION (CKP) SENSOR REPLACEMENT (24X CKP SENSOR)
REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Raise the vehicle on a hoist. Refer to Vehicle Lifting
3. Remove the crankshaft harmonic balancer.
4. Note the routing of the sensor harness before removal.
5. Remove the harness retaining clip (3) with the bolt (4).
6. Disconnect the sensor electrical connector.
7. Remove the sensor bolts (4).
8. Remove the sensor (1).
INSTALLATION PROCEDURE
1. Install the 24X crankshaft position sensor (1) with bolts (4) and the route harness as noted during removal.
2. Install the harness retaining clip (3) with the bolt (4).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 10 N.m (89 lb in).
3. Connect the sensor electrical connector.
4. Install the balancer on the crankshaft.
5. Lower vehicle.
6. Perform the CKP System Variation Learn Procedure. See: Testing and Inspection/Programming and Relearning
