Rendezvous AWD V6-3.4L VIN E (2005)
1. Connect the front wheel speed sensor jumper harness connector (2) to the wheel speed sensor.
2. Install the harness (4) to control arm retaining clips (3).
3. Install the harness (4) to splash shield retaining clip (5).
4. Lower the vehicle.
5. Connect the front wheel speed sensor jumper harness to ABS harness connector (8).
6. Turn the ignition switch to the RUN position, with the engine off.
7. Perform the diagnostic system check. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check - Vehicle
