Rendezvous AWD V6-3.4L VIN E (2005)
16.
Place a small cloth between the steering column upper and lower tilt heads as shown. This will prevent the stop bumpers from falling into the
steering column when they are removed.
17.
Remove the two stop bumpers from the steering column lower tilt head.
18.
Install the new stop bumper into the steering column lower tilt head.
19.
Install the upper steering column cover.
20.
Install the ignition lock cylinder into the lock cylinder case.
21.
Install the retaining screw to the upper steering column trim cover.
22.
Install the lower steering column trim cover and screws.
23.
Install the tilt lever close out plate.
24.
Install the steering wheel and nut.
Tighten
Tighten the nut to 41 Nm (30 lb-ft).
25.
Install the inflatable restraint steering wheel module.
26.
Install the knee bolster trim panel.
27.
Enable the SIR system.
28.
Connect the battery negative cable.
