Rendezvous AWD V6-3.4L VIN E (2005)
Tighten the nuts to 47 N.m (35 lb ft).
10. Connect the lower control arms to the steering knuckles. Refer to Steering Knuckle Replacement in Front Suspension.
11. Connect the wheel speed sensor wiring harnesses to the lower control arms.
12. Connect the wheel speed sensor harness connectors.
13. Connect the power steering cooler pipe to the pressure hose. Refer toPower Steering Cooler Pipe/Hose Replacement in Power Steering System.
14. Install front fender liner. Refer to Front Fender Liner Replacement (See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and
Repair) in Exterior Trim.
15. Install the power steering gear . Refer to Power Steering Gear Replacement in Power Steering System.
16. Install the stabilizer shaft. Refer to Stabilizer Shaft Replacement in Front Suspension.
17. Install the front engine splash shield. Refer to Splash Shield Replacement - Engine (See: Body and Frame/Splash Guard/Service and Repair) in
Body Front End.
18. Install the front tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
19. Lower the vehicle.
20. Remove the engine support fixture. Refer to Engine Support Fixture in Engine Mechanical - 3.4L and Engine Support Fixture in Engine
Mechanical - 3.6L (LY7).
