Rendezvous AWD V6-3.6L VIN 7 (2004)
5. Release the tabs on the housing and remove.
6. Remove the rear object sensor bezel by pushing it through the fascia.
INSTALLATION PROCEDURE
IMPORTANT: Do not refinish previously painted sensors.
1. Paint the new rear object sensor. Refer to Basecoat/Clearcoat Paint Systems in Paints/Coatings.
2. Check the paint thickness to ensure it does not exceed 6 mils using a paint thickness gage suitable for non-ferrous metals. Refer to Paint Gages in
Paints/Coatings.
3. Align the keyhole (2) with the key (1) and press the rear object sensor bezel flush to the fascia.
