Rendezvous AWD V6-3.6L VIN 7 (2004)
Body Control Module: Procedures
BODY CONTROL MODULE (BCM) PROGRAMMING/RPO CONFIGURATION
INTRODUCTION
During body control module (BCM) related service, the procedures below are designated to set-up the BCM correctly. Before you start, read these
procedures carefully and completely.
SETUP NEW BODY CONTROL MODULE (BCM)
IMPORTANT:
-
The BCM will not function properly if the Setup New BCM procedure is not performed.
-
Make sure the battery is fully charged before performing the setup procedure.
-
Make sure all disconnected devices and connectors have been reconnected
-
If the scan tool displays UNABLE TO PROGRAM BCM. BCM IS SECURED, then the BCM must be replaced and this procedure must be
repeated on a new BCM
1. Connect a scan tool to the data link connector (DLC).
2. Turn the ignition switch ON.
3. Select Diagnostics and input all of the required data when prompted by the scan tool.
4. Select BODY CONTROL MODULE.
5. Select SPECIAL FUNCTIONS.
6. Select New VIN and input all required data.
7. Exit back to the SPECIAL FUNCTIONS menu.
8. Select BCM REPROGRAMMING.
9. The scan tool will display DO YOU WANT TO SETUP A BODY CONTROL MODULE? At the prompt, select the SETUP BCM soft-key on the
scan tool.
10. The scan tool will display: NOW SETTING UP THE NEW BODY CONTROL MODULE.
11. When the BCM has been setup successfully, the scan tool will display: BODY CONTROL MODULE SETUP IS COMPLETE.
12. Exit back to the SPECIAL FUNCTIONS menu.
13. Select Point of Sale in this menu.
14. Input all of the required data when prompted by the scan tool.
15. Exit back to the SET OPTIONS menu.
16. Select Option Configuration.
17. Input all of the required data when prompted by the scan tool.
18. Select the BCM Setup SDM part number in BCM and follow the on screen instructions.
19. Select BCM New VIN and follow the on screen instructions.
20. Select the BCM Point of Sale and follow the on screen instructions
21. After all of the previous procedures are complete proceed with the Theft Deterrent Re-learn procedure. Refer to Programming Theft Deterrent
System Components in Theft Deterrent.
22. If the scan tool displays UNABLE TO PROGRAM BCM. BCM IS SECURED, then the BCM must be replaced and this procedure must be
repeated on a new BCM.
NOTE: After the above procedure has been completed, personalization of the BCM defaults to the factory settings. Inform the customer that the
personalization settings must be set again.
IMPORTANT: After programming, perform the following to avoid future misdiagnosis:
1. Turn the ignition OFF for 10 seconds.
2. Connect the scan tool to the data link connector.
3. Turn the ignition ON with the engine OFF.
4. Use the scan tool in order to retrieve history DTCs from all modules.
5. Clear all history DTCs.
