Rendezvous AWD V6-3.6L VIN 7 (2004)
3. Install the power mirror switch. Refer toPower Mirror Switch Replacement. See: Mirrors/Power Mirror Switch
4. Align the front door trim panel to the front door inner panel, guiding the front door handle through the trim panel.
5. Install the upper edge of the front door trim panel to the top edge of the inner door panel, pressing down firmly until the front door trim panel is
fully seated.
6. Install the front door trim panel by firmly pressing the retainer clips until the clips are fully seated around the perimeter of the front door trim
panel.
Notice: Refer to Fastener Notice in Cautions and Notices.
7. Install the screws to the front door trim panel.
Tighten the front door trim panel screws to 2 N.m (18 lb in).
8. Install the power window switch. Refer to Power Window Switch Replacement. See: Sensors and Switches/Sensors and Switches - Windows and
Glass/Power Window Switch
Trim Panel Replacement - Side Front Door (Rendezvous)
Trim Panel Replacement - Side Front Door (Rendezvous)
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Removal Procedure
1. Open the door.
2. Disconnect the power window switch assembly. Refer to Power Window Switch Replacement. See: Sensors and Switches/Sensors and Switches -
Windows and Glass/Power Window Switch
3. Remove the screws from the front door trim panel
4. Use the J 38778 to remove the trim panel.
1. Reposition the electrical harness connectors.
2. Remove the trim panel from the vehicle.
Installation Procedure
