Rendezvous AWD V6-3.6L VIN 7 (2004)
Rear Door Striker: Adjustments
Lock Striker Adjustment - Door
Tools Required
J 39346 Mini-Wedge Door Striker Aligner
Mini-Wedge Door Striker Aligner Adjustment Procedure
Important: Properly align the door before adjusting the striker.
1. Open the door.
2. Loosen the striker screws just enough to allow the movement of the door striker.
3. Install J 39346 .
Important: Do not slam the door.
4. Close the door while holding the outside the handle in the open position.
5. Open the door.
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Install the striker screws.
Tighten the striker screws to 24 N.m (18 lb ft).
7. Remove J 39346 .
8. Close the door.
Non Mini-Wedge Door Striker Adjustment Procedure
Important: Properly align the door before adjusting the striker.
1. Open the door.
2. Loosen the striker screws just enough to allow the movement of the door striker.
3. Adjust the door striker up or down and inboard or outboard as required.