buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Headliner Replacement (Aztek)|Page 12423 > < Glove Compartment Lock Cylinder|Service and Repair|Page 12418
Page 1
background image

Headliner: Service and Repair
Headliner Replacement (Aztek)

Headliner Replacement (Aztek)

Tools Required

J 38778 Door Trim Pad Clip Remover

Removal Procedure

Caution:  Do not attempt to repair or alter the head impact energy-absorbing material glued to the headliner or to the garnish trims. If the material
is damaged, replace the headliner and/or the garnish trim. Failure to do so could result in personal injury.

1. Remove the windshield garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar  (See: Trim Panel/Service and

Repair/Garnish Molding Replacement - Windshield Pillar) .

2. Remove the sunroof switch, if equipped. Refer to Sunroof Switch Replacement  (See: Roof and Associated Components/Sunroof /

Moonroof/Sunroof / Moonroof Switch/Service and Repair/Removal and Replacement) in Roof.

3. Remove the sunroof lace, if equipped.
4. Remove the sunshades. Refer to Sunshade Replacement  (See: Sun Visor/Service and Repair/Removal and Replacement/Sunshade Replacement) .
5. Remove the overhead console, if equipped. Refer to Console Replacement - Overhead (Rendezvous)  (See: Console/Service and Repair/Console

Replacement - Overhead (Rendezvous))Console Replacement - Overhead (Aztek)  (See: Console/Service and Repair/Console Replacement -
Overhead (Aztek)) .

6. Remove the upper center trim panels. Refer to Trim Panel Replacement - Upper Center Pillar  (See: Trim Panel/Service and Repair) .
7. Remove the upper quarter trim panels. Refer to Trim Panel Replacement - Rear Quarter Upper (Aztek)  (See: Trim Panel/Service and Repair/Trim

Panel Replacement - Rear Quarter Upper (Aztek))Trim Panel Replacement - Rear Quarter Upper (Rendezvous)  (See: Trim Panel/Service and
Repair/Trim Panel Replacement - Rear Quarter Upper (Rendezvous)) .

8. Remove the rear upper garnish molding. Refer to Garnish Molding Replacement - Rear Upper  (See: Trim Panel/Service and Repair/Garnish

Molding Replacement - Rear Upper) .

9. Remove the left and the right lamps from the roof side rail. Refer to Roof Side Rail Lamp Replacement   .

10. Use J 38778  in order to remove the rear headliner push-in retainers.
11. Remove the headliner from the roof through the rear of the vehicle.

Installation Procedure

1. Install the headliner to the roof through the rear of the vehicle.
2. Push the headliner rearwards in order to lock the headliner into place.

Headliner Replacement (Aztek)|Page 12423 > < Glove Compartment Lock Cylinder|Service and Repair|Page 12418