Rendezvous AWD V6-3.6L VIN 7 (2004)
Trim Panel: Service and Repair
Garnish Molding Replacement - Rear Upper
Garnish Molding Replacement - Rear Upper
Removal Procedure
1. Remove the rear upper garnish molding by pulling the rear roof garnish molding to release the push-in retainers.
Important: The seat belt escutcheon is part of the seat belt assembly.
2. Remove the seat belt escutcheon from the rear roof garnish molding using a small flat bladed tool.
3. Disconnect the electrical connector from the rear cargo lamp.
4. Remove the rear seat belt from the slot in the rear roof garnish molding.
5. Remove the rear roof garnish molding from the vehicle.
Installation Procedure
1. Install the rear seat belt to the slot in the rear roof garnish molding.
2. Connect the electrical connector to the rear cargo lamp.
3. Install the seat belt escutcheon to the rear roof garnish molding.
4. Install the push-in retainers to the rear roof garnish molding, applying pressure on the molding to secure at all retainer locations.
