Rendezvous AWD V6-3.6L VIN 7 (2004)
1. Keeping the position lock pin in the new SOPS, position the SOPS switch over the drive cables and press down. If the SOPS does not slide into
position, the ridges on the drive cable housings will not go into the grooves on the back of the SOPS. Lift each cable into the SOPS, and press
down on the SOPS assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the SOPS screw (2) to the switch.
Tighten
Tighten the SOPS screw to 2 N.m (18 lb in).
3. Connect the electrical connector to the SOPS.
4. Install the sunroof actuator.
5. Remove the position lock pin (1) or the 2 wires from the switch.
