Rendezvous AWD V6-3.6L VIN 7 (2004)
3. Install the power sunroof switch to the roof, pressing into place until fully seated.
Sunroof Opening Position Switch Replacement
SUNROOF OPENING POSITION SWITCH REPLACEMENT
TOOLS REQUIRED
J 41718 Sunroof Timing Pins
REMOVAL PROCEDURE
IMPORTANT:
-
The Sunroof Opening Position Switch (SOPS) (3) is aligned to the drive cables. The switch comes from the factory set to the window panel
CLOSED position. A position lock pin (1) has been installed on the top of the switch. The pin (1) must remain until after the installation of the
actuator and of the switch. The lock pin locks the drive gears in place and must be removed before operation of the sunroof module.
-
If you reuse a Sunroof Opening Position Switch, place the sunroof window panel in the CLOSED position. Install the sunroof timing pins J 41718.
Install a position lock pin, or install 2 wires, such as the ends of a paper clip, then remove the SOPS from the sunroof module. The SOPS timing
will be lost if you do not follow this procedure.
1. Position the sunroof window panel to the closed position.
2. Remove the sunroof module from the vehicle.
IMPORTANT: Before removing the SOPS from the sunroof module, the J 41718 sunroof timing pins must be installed to lock the cable/cam
mechanism into position.
