Rendezvous AWD V6-3.6L VIN 7 (2004)
3. The cable/cam mechanisms, on both sides of the sunroof window, contain a set of timing holes. These holes are aligned to the sunroof window
panel in the CLOSED position. Remove the left and right side front sunroof window panel screws.
Align the timing holes. Use a flat-bladed tool to push the cable/cam mechanism forward or rearward.
Install the J 41718 sunroof timing pins into the left and right sunroof window panel screw holes.
4. Remove the sunroof actuator.
5. Disconnect the electrical connector from the SOPS (3).
6. Remove the SOPS screw (2) from the switch.
7. Hold down on both drive cables, and lift straight up to remove the SOPS from the sunroof module.
INSTALLATION PROCEDURE
IMPORTANT: The new SOPS comes with a position lock pin that is installed on top of the SOPS. This locks the timing gears in place. Do not
remove this pin until after you have installed the SOPS and the actuator.