Rendezvous AWD V6-3.6L VIN 7 (2004)
Notice: Proper stoplamp switch adjustment is essential. Improper stoplamp switch adjustment may cause brake drag, heat buildup and excessive
brake lining wear.
1. Install the brake booster and position to the cowl and the mounting plate.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the brake booster mounting nuts.
Tighten the brake booster mounting nuts to 25 Nm (18 ft. lbs.).
3. Install the brake booster push rod (2) to the brake pedal (1).
4. Install the brake booster rod retaining washer and clip to the brake pedal assembly.
5. Adjust the stop lamp switch.
6. Connect the fuel pipe retainer to the wheelhouse stud.
7. Install the transmission filler tube.
8. Using the engine support fixture, raise the powertrain to its original position.
9. Raise the vehicle.
10. Using an appropriate jack, raise the left side of the frame so that the frame to body bolts can be installed.
