Rendezvous AWD V6-3.6L VIN 7 (2004)
Cap or tape off the A/C discharge hose.
16. Remove the bolt which secures the evaporator inlet tube to the condenser block.
17. Disconnect the evaporator inlet tube from the condenser block.
18. Cap or tape off the evaporator inlet tube.
19. Remove the radiator and condenser assembly.
20. Remove the condenser tube clip bolt.
21. Remove the condenser mounting bolts.
22. Remove the condenser from the radiator.
Installation Procedure
1. Install the condenser to the radiator.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the mounting bolts that secure the condenser to the radiator.
Tighten the bolts to 6 Nm (53 inch lbs.).
3. Install the condenser tube clip bolt.
Tighten the bolt to 2.5 Nm (22 inch lbs.).
4. Install the radiator and condenser assembly.
5. Remove the cap or the tape from the evaporator inlet tube.
6. Install a new seal washer to the evaporator inlet tube.