Rendezvous AWD V6-3.6L VIN 7 (2004)
Engine Block Heater: Service and Repair
Coolant Heater Cord Replacement
Coolant Heater Cord Replacement (LY7)
Removal Procedure
1. Remove the air inlet duct.
2. Remove the coolant (block) heater cord from the transmission fill tube.
3. Raise and support the vehicle.
4. Remove the catalytic converter.
5. Remove the engine coolant (block) heater cord from the engine coolant heater.
6. Remove the engine coolant (block) heater cord.
Installation Procedure
1. Install the engine coolant (block) heater cord above the transmission.