Rendezvous AWD V6-3.6L VIN 7 (2004)
Engine Mount: Service and Repair
Engine Support Fixture
Engine Support Fixture
^
Tools Required
-
J 28467-34 Lift Hook Wing Nut and Washer (2)
-
J 28467-6A Bracket Assembly (2)
-
J 28467-7A Bolt Hook (2)
-
J 28467-500 Engine Support Fixture
-
J 28467-B Side Rail Support Bracket
Installation Procedure
Important: Supplemental support provided near the bottom of the transmission will be required to prevent the powertrain from rotating if the
frame is lowered or removed.
1. Remove the engine mount struts.
2. Install a J 28467-B and retention pin to each end of the J 28467-500 beam (2).
3. Position the J 28467-B to the left and right side inner fender rails in order to install the J 28467-500.
4. Assemble the following to create 2 lift hook assemblies as shown:
^
J 28467-34
^
J 28467-6A
^
J 28467-7A