Rendezvous AWD V6-3.6L VIN 7 (2004)
3. Remove the oil pump drive clamp bolt.
4. Remove the oil pump drive clamp.
5. Remove the oil pump drive.
Installation Procedure
1. Apply prelube GM P/N 1052365 or the equivalent to the oil pump drive gear.
2. Apply engine oil to the oil pump drive gear assembly for ease of assembly.
3. Install the oil pump drive gear assembly.
4. Install the oil pump drive gear clamp.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the oil pump drive gear clamp bolt.
Tighten the oil pump drive gear clamp bolt to 36 Nm (27 ft. lbs.).
6. Connect the fuel feed and return pipe to the fuel injector rail.
7. Install the upper intake manifold.
Camshaft Rear Bearing Hole Plug Replacement
Removal Procedure
1. Remove the engine flywheel.
2. Remove the camshaft rear bearing hole plug.
Installation Procedure