Rendezvous AWD V6-3.6L VIN 7 (2004)
6. Install the exhaust crossover pipe to right bank exhaust manifold nuts (3).
7. Raise the powertrain and/or lower the vehicle until the frame insulators contact the chassis.
8. Install the two frame left side bolts.
9. Install the left front wheel liner.
10. Remove the utility stand.
11. Install the catalytic converter.
12. Connect the intermediate steering shaft to the steering gear.
13. Lower the vehicle.
14. Connect the torque struts to the engine.
15. Install the master cylinder fluid level sensor.
16. Install the air inlet duct.
