Rendezvous AWD V6-3.6L VIN 7 (2004)
1. Install the mode actuator.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the mode actuator mounting screws.
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
IMPORTANT: Align the counted number of threads on the mode actuator push rod (2) with the tip of the retainer clip (1).
3. Connect the mode actuator push rod (2) to the retainer clip (1).
4. Close the push rod retainer clip (1).
5. Connect the mode actuator electrical connector.
6. Connect the I/P wiring harness clip to the I/P support bracket.
7. Install the knee bolster.
8. Recalibrate the actuators. Refer to Re-Calibrating Actuators.
