Rendezvous AWD V6-3.6L VIN 7 (2004)
19. Remove the TXV mounting screws.
20. Remove the TXV from the evaporator core.
INSTALLATION PROCEDURE
1. If replacing the evaporator core, add the specified amount of PAG oil directly to the evaporator core. Refer to Refrigerant System Capacities.
2. Install the new sealing washers onto the evaporator line.
3. Install the TXV to the evaporator core.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the TXV mounting screws.
Tighten
Tighten the screws to 3.2 N.m (28 lb in).
IMPORTANT: The evaporator temperature sensor must be located in the same position on the new evaporator core.
5. The evaporator temperature sensor should be approximately 3.5 cm (1.4 in) from the side and 5.0 cm (2.0 in) from the bottom corner of the
evaporator core.
6. Install the evaporator temperature sensor.
