Rendezvous AWD V6-3.6L VIN 7 (2004)
2. Install the evaporator inlet tube.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the bracket bolt to the evaporator outlet tube.
Tighten
Tighten the bolt to 5.5 N.m (45 lb in).
4. Remove the cap or tape from the condenser.
5. Connect the inlet tube to the condenser.
6. Install the bolt that secures the inlet tube to the condenser.
Tighten
Tighten the bolt to 16 N.m (12 lb ft).
7. Remove the cap or tape from the TXV.
8. Connect the inlet tube to the outlet tube.
9. Connect the outlet tube to the TXV.
