Rendezvous AWD V6-3.6L VIN 7 (2004)
Compressor Clutch Relay: Service and Repair
COMPRESSOR RELAY REPLACEMENT
TOOLS REQUIRED
J 43244 Relay Puller Pliers
REMOVAL PROCEDURE
1. Remove the electrical center cover.
2. Locate the compressor relay. Refer to Electrical Center Identification Views to locate the electrical center where the compressor relay exists.
IMPORTANT:
-
Always note the orientation of the relay.
-
Make sure the electrical center is secure, as not to put added stress on the wires or terminals.
1. Using the J 43244 (1) position the tool on opposing corners of the compressor relay (2).
NOTE: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the
electrical center.
2. Remove the compressor relay (2) from the electrical center.
INSTALLATION PROCEDURE