Rendezvous AWD V6-3.6L VIN 7 (2004)
Center Mounted Brake Lamp: Service and Repair
HIGH MOUNTED STOP LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Remove the screws from the high mounted stop lamp.
2. Remove the high mounted stop lamp from the roof panel.
3. Disconnect the electrical connector from the high mounted stop lamp.
4. Remove the high mounted stop lamp from the roof panel.
INSTALLATION PROCEDURE
1. Position the high mounted stop lamp to the roof panel.
2. Connect the electrical to the high mounted stop lamp.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the high mounted stop lamp screws to the high mounted stop lamp.
Tighten
Tighten the high mounted stop lamp screws to 3.5 N.m (31 lb in).