Rendezvous AWD V6-3.6L VIN 7 (2004)
5. Connect the electrical connector to the headlamp.
6. Position the headlamp to the upper fascia support.
7. Press the headlamp into the upper fascia support until the ball stud is fully seated.
8. Install the thumb screw to the rear of the headlamp.
9. Engage the headlamp vertical retainer, by sliding downward until fully seated.
10. Check the headlamp aim, if a new headlamp was installed, or if service or repairs in the front end area were made.
11. Close the hood.
