Rendezvous AWD V6-3.6L VIN 7 (2004)
11. Remove the bolt that secures the evaporator inlet tube to the condenser fitting.
12. Disconnect the evaporator inlet tube from the condenser.
13. Cap or tape off the condenser.
14. Remove the bracket bolt from the evaporator outlet tube.
IMPORTANT: Gently lift up on the evaporator outlet tube bracket to allow enough clearance to slide the evaporator inlet tube underneath.
15. Remove the evaporator inlet tube.
16. Remove and discard the sealing washers.
INSTALLATION PROCEDURE
1. Install new sealing washers onto the evaporator inlet tube.
IMPORTANT: Gently lift up on the evaporator outlet tube bracket to allow enough clearance to slide the evaporator inlet tube underneath.
