Rendezvous AWD V6-3.6L VIN 7 (2004)
14. If necessary, perform the following steps:
1. Remove the ECM bracket bolts.
2. Remove the ECM bracket (1).
INSTALLATION PROCEDURE
1. Install the ECM bracket, as necessary.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the ECM bracket bolts.
Tighten
Tighten the ECM bracket bolts to 10 N.m (89 lb in).
NOTE: In order to prevent any possible electrostatic discharge damage to the ECM, do not touch the connector pins.
