Rendezvous AWD V6-3.6L VIN 7 (2004)
Knock Sensor: Service and Repair
Knock Sensor (KS) Replacement-Bank 2
KNOCK SENSOR (KS) REPLACEMENT - BANK 2
REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Disconnect the battery negative cable.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Remove the knock sensor (KS) electrical connector bracket bolt (2) located near the oil filter (3).
5. Remove the KS bolt (1).
6. Disconnect the KS electrical connector.
INSTALLATION PROCEDURE
