Rendezvous AWD V6-3.6L VIN 7 (2004)
Variable Valve Timing Actuator: Service and Repair
Camshaft Position (CMP) Actuator Replacement - Bank 2 (Left) Exhaust
CAMSHAFT POSITION ACTUATOR REPLACEMENT - BANK 2 (LEFT SIDE) EXHAUST
Special Tools: EN 46108 Timing Chain Retention Tool
Removal Procedure
Important: To identify the camshaft drive design, refer to Camshaft Timing Drive Design Identification. See: Engine, Cooling and
Exhaust/Engine/Timing Components/Application and ID
1. Remove the upper intake manifold with the lower intake manifold. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair
2. Remove the left bank camshaft cover. See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Valve Cover/Service and Repair
3. Remove the camshaft sensors. See: Crankshaft Position Sensor/Service and Repair
4. Remove the camshaft position actuator solenoid.
Important: Rotate the crankshaft balancer in a clockwise rotation ONLY.
5. Rotate the crankshaft using the crankshaft balancer bolt until the camshafts are in a neutral (low tension) position. The camshaft flats will be
parallel with the camshaft cover rail (1).
