Rendezvous AWD V6-3.6L VIN 7 (2004)
6. Disconnect the fuel feed and EVAP pipes from the fuel tank.
7. Cap the fuel pipes in order to stop any fuel leakage.
8. Remove the fuel pipe retainers with the fuel pipes.
9. Note the position of the fuel and EVAP pipes and the fuel and EVAP pipe attaching hardware for installation.
10. Inspect the pipes for bends, kinks, and cracks.
11. Replace the pipe or pipes as required.
INSTALLATION PROCEDURE
CAUTION: In order to Reduce the Risk of Fire and Personal Injury: If nylon fuel pipes are nicked, scratched or damaged during
installation, they must be replaced.
NOTE:
-
Always re-attach the fuel lines and fuel filter with all original type fasteners and hardware.
-
Do not repair sections of fuel pipes.
-
Secure the fuel pipes to the frame in order to prevent chafing. Maintain a minimum of 13 mm (1/2 inch) clearance around a pipe in order
to prevent contact and chafing. Maintain a minimum of 19 mm (3/4 inch) around any moving part.
-
Do not allow the fuel pipes to come into contact with the fuel tank or underbody.
