Rendezvous AWD V6-3.6L VIN 7 (2004)
Throttle Body: Service and Repair
Throttle Body Assembly Replacement
THROTTLE BODY ASSEMBLY REPLACEMENT
REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Remove the air cleaner intake duct.
NOTE: DO NOT use any mechanical device such as pliers or screwdrivers to disengage the connector. In order to prevent damage to the connector
or harness wiring, both of the latches on the connector must be depressed with finger pressure only. When the latches are depressed the connector
must then be pulled straight back without pulling on the wires in order to disengage. Failure to follow this procedure can lead to connector or wiring
harness damage and failure.
3. Remove the throttle body electrical connector.
4. Remove the throttle body bolts.
