Rendezvous AWD V6-3.6L VIN 7 (2004)
Ignition Coil: Service and Repair
Ignition Coil(S) Replacement - Bank 1
IGNITION COIL(S) REPLACEMENT - BANK 1
REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Disconnect the intermediate steering shaft from the steering gear.
4. Remove and reposition the front portion of the front fender liners in order to gain access to the frame front bolts.
5. Lower the vehicle.
6. Position a floor jack at the front center section of the frame in order to support the powertrain.
7. Remove the frame front bolts.
IMPORTANT: Do not lower the powertrain more than 100 mm (4 in).
8. Carefully lower the powertrain in order to provide access.
9. Reposition the evaporative emission (EVAP) purge hoses as necessary in order to provide access.
10. Remove the applicable ignition coil electrical connectors.
