Rendezvous AWD V6-3.6L VIN 7 (2004)
Intake Air Temperature (IAT) Sensor: Service and Repair
MASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Remove the mass air flow (MAF) electrical connector.
3. Remove the air cleaner intake duct.
4. Remove the MAF sensor screws.
5. Remove the MAF sensor and the MAF sensor seal.
INSTALLATION PROCEDURE
1. Install the MAF sensor seal to the air cleaner cover.
IMPORTANT: Do NOT use any lubricant other than clean water on the MAF seal.
