Rendezvous AWD V6-3.6L VIN 7 (2004)
4. Connect the electrical connector to the blower control processor assembly.
5. Install the blower motor to the HVAC module assembly.
6. Install the blower motor mounting screws.
Tighten
Tighten the screws to 1.8 N.m (16 lb ft).
7. Connect the blower motor electrical connector.
8. Install the right side I/P insulator.
HVAC Control Module
HVAC CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the I/P cluster trim plate bezel.
2. Remove the HVAC control module retaining screws.
3. Pull the HVAC control module out from the I/P.