Rendezvous AWD V6-3.6L VIN 7 (2004)
Inflatable Restraint Sensing And Diagnostic Module: Service and Repair
INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENT
REMOVAL PROCEDURE
CAUTION:
-
Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is
securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause
SIR deployment, personal injury, or unnecessary SIR system repairs.
-
Refer to SIR Caution in Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 9.
2. Remove the passenger front seat.
3. Remove the passenger front carpet retainer. Roll back the carpet.
4. Remove the right side cowl trim panel.
5. Remove the right side insulator panel.
6. Remove the connector position assurance (CPA) (3) from the SDM wiring harness connector (2) on the inflatable restraint.
7. Disconnect the SDM wiring harness connector (2) from the SDM (1).
