Rendezvous AWD V6-3.6L VIN 7 (2004)
1. Remove any dirt, grease, and other contaminants from the mounting surface.
2. Connect the sensor harness connector (3) to the sensor (1).
3. Install the orange CPA (2) into the yellow sensor harness connector (3).
4. Position the sensor on the upper radiator core support (3).
5. Point the arrow on the sensor toward the front of the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the sensor bolts (1).
Tighten
Tighten the bolts to 9 N.m (80 lb in).
7. Secure the fascia to the radiator support.
8. Install the retainers that hold the upper front bumper fascia to the radiator support.
9. Install the grille.
10. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1.
