Rendezvous AWD V6-3.6L VIN 7 (2004)
Knock Sensor: Service and Repair
Knock Sensor (KS) Replacement-Bank 1
KNOCK SENSOR (KS) REPLACEMENT - BANK 1
REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the catalytic converter.
4. Disconnect the intermediate steering shaft from the steering gear.
5. Position a utility stand beneath the rear center section of the frame in order to support the powertrain.
6. Remove the frame rear bolts.
IMPORTANT: Do not lower the powertrain more than 100 mm (4 in).
7. Carefully lower the powertrain in order to provide access.
IMPORTANT: Use a universal or swivel socket with a long extension in order to remove the bolts.
