Rendezvous AWD V6-3.6L VIN 7 (2004)
Power Steering Line/Hose: Service and Repair
Power Steering Return Hose Replacement
Power Steering Return Hose Replacement (LY7)
Removal Procedure
1. Siphon the power steering fluid from the reservoir.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the right front tire and wheel.
4. Remove the inner fender liner enough to gain access to the front frame bolts.
5. Use a utility stand to support the right side of the frame.
6. Remove the right side frame-to-body bolts.
7. Use the utility stand to lower the right side of the frame and powertrain.
8. Disconnect the power steering return hose from the power steering cooling pipe.
9. Disconnect the power steering reservoir inlet hose from the power steering pump.
10. Cap off the hoses, pipes and pump to prevent contamination.
11. Use the utility stand to raise the frame and powertrain.
12. Install the right side frame bolts.
