Rendezvous AWD V6-3.6L VIN 7 (2004)
2. Install the outer tie rod (2) to the steering knuckle (1).
3. Important: This is a prevailing torque type fastener. This fastener may be reused ONLY if:
^
The fastener and its counterpart are clean and free from rust
^
The fastener develops 2 Nm (18 inch lbs.) of torque (drag) against its counterpart prior to the fastener seating.
If the fastener does not meet these criteria, REPLACE the fastener.
Notice: Refer to Fastener Notice in Service Precautions.
Install the tie rod ball stud nut.
Tighten the tie rod ball stud nut to 30 Nm (22 ft. lbs.) + 120 degrees (2 flats).
Important: Ensure that 2.5-4.5 tie rod end threads are visible beyond the tie rod nut nylon.
4. Install the front tire and wheel.
5. Lower the vehicle.
