Rendezvous AWD V6-3.6L VIN 7 (2004)
Stabilizer Link: Service and Repair
Front Suspension
Stabilizer Shaft Link Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the stabilizer shaft link bolt and nut.
3. Use a pry bar in order to remove the stabilizer shaft link insulators and the spacer.
Installation Procedure
1. Use a pry bar in order to install the stabilizer shaft link insulators and the spacer.
2. Install the stabilizer shaft link and insulators.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the stabilizer shaft link bolt and nut.
Tighten the stabilizer shaft link nut to 23 Nm (17 ft. lbs.).
4. Lower the vehicle.