Rendezvous AWD V6-3.6L VIN 7 (2004)
2. Install the bolts (1) into the wheel bearing/hub assembly. Tighten the wheel bearing/hub bolts to 130 Nm (96 lb ft).
3. Install the wheel drive shaft into the wheel bearing and tighten the nut. Refer to Rear Wheel Drive Shaft Replacement. Tighten the nut to 260 Nm
(192 lb ft).
4. Connect the sensor lead.
5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
6. Lower the vehicle.
Drum Brake System
Wheel Bearing/Hub Replacement - Rear (Drum Brake)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the brake drum.
4. Remove and discard the wheel bearing/hub bolts.
5. Remove the wheel bearing/hub.
