Rendezvous AWD V6-3.6L VIN 7 (2004)
9. Use the utility stand in order to raise the frame and powertrain until the frame insulators contact the chassis.
10. Remove the transmission jack.
11. Install the left side frame bolts.
12. Remove the utility stand support from the left side of the frame.
13. Connect the catalytic converter pipe to the exhaust manifold (LA1) or crossover pipe (LY7).
14. Caution: When installing the intermediate shaft make sure that the shaft is seated prior to pinch bolt installation. If the pinch bolt is
inserted into the coupling before shaft installation, the two mating shafts may disengage. Disengagement of the two mating shafts will
cause loss of steering control which could result in personal injury.
Install the intermediate shaft (1) to the steering gear (2).
15. Install the trans mount nuts at the frame.
16. Install the left drive axle to the transaxle.
17. Install the left lower ball joint to the left steering knuckle.
