Rendezvous AWD V6-3.6L VIN 7 (2004)
Shift Cable: Service and Repair
Range Selector Cable Replacement
Automatic Transmission Range Selector Cable Replacement
Removal Procedure
1. Remove the throttle body air inlet duct.
2. Use a flat-bladed tool in order to remove the retaining clip from the automatic transaxle range selector cable.
3. Use a large flat-bladed tool in order to remove the automatic transaxle range selector cable from the cable lever.
4. Use pliers in order to depress the cable retainers.
5. Remove the automatic transaxle range selector cable from the automatic transaxle range selector cable bracket.
6. Remove the knee bolster.
7. If the vehicle is equipped with a console shift, perform the following steps:
1. Remove the console trim plate.
2. Remove the transaxle shift cable from the floor shift control.
